The sheet metal

List the sheet metal

  • • original build sheet...it’s believed to retain all the original sheet metal...there wasn’t any rust so no sheet metal work was needed...to larry’s knowledge all the sheet metal is original to the car...

    $ 399005085570152

  • All of the sheet metal were thoroughly stripped, prepared, primed, painted, and sealed...gm nos sheet metal was located and purchased one piece at a time...new old stock sheet metal was collected over...

    $ 125000

  • I think a sheet metal tech could remove it simply as it is easily accessed...  both front and rear valances (sheet metal below bumpers)...  if you pick it up with an open trailer you'll need extra space...

    $ 900

  • In addition i have the stainless steel “pinch weld” trim that goes around the convertible top where it meets the sheet metal... the body does need some work, but all the original sheet metal is intact...

    $ 100

  • Hi i am selling a belair original ca car super solid with over $60k invested in custom frame, sheet metal and suspension parts...the rear trim, front and rear bumpers  where professionally lead into the...

    $ 25000

  • The other side remains to be finished, but all of the sheet metal required to complete the work comes with the car...in addition to the sheet metal mentioned above, the car comes with one new fender (drivers...

    $ 2500

  • This ford bronco is an uncut gem with low original miles and all original sheet metal...this was a phenomenal find out of south carolina as none of the sheet metal has been replaced and the frame and...

    $ 29900

  • Chevy caprice speed has a rebuilt motor a m22 trans that grinds a little going into second gear car has rust in trunk pan and drivers floor pan i have the sheet metal to repair also has rust on outside...

  • Paint and body   the sheet metal on this truck is laser straight...steel sheet metal reinforced bed with steel wheel tubs, blasted, primed and coated with a beautiful black textured bed liner...

    $ 1000

  • The sheet metal is all stock with nos sheet metal, the wood was a 1 year process with african  mahogany inserts and maple...this is your chance to own or add to your collection one of the finest woodies...

    $ 35000

Did not find what you're looking for? Try again

Related Searches the sheet metal