The machine shop
List the machine shop
-
The machine shop bored the cylinders when reconditioning and made it a 400...the machine shop redid the heads with new valves and springs and all the usual procedures that a set of heads goes through at...
$ 14750
-
After a trip to the machine shop, the engine got all new aluminum heads, intake, water pump, etc...a perfect street machine that's mild-mannered around town, but when you mash the go pedal, you better...
$ 35995
-
Straight from the machine shop, the racy mill utilizes 509 cubic inches that produce 669 horsepower and approx... what started out as a small restoration shop in a garage back in has grown to a sq...
$ 10000
-
Corvette coupe factory beautiful rally red…great original body…fresh rebuilt original engine by fraser dante with complete full matching numbers…very rare with full power steering and fresh power brakes…red...
$ 64950
-
Additional details: amc rebel machine...amc offered the then-biggest version of its second-generation v-8 in the rebel machine for , bored and stroked to 390 ci...this rebel machine is powered by amc&rsquo...
$ 54900
-
Lots of parts, hardtops, a short block that has been through the machine shop, heads, windshields, etc...one nice driver, one solid car not hard to bring back, one very solid body in the throes of a total...
$ 8000
-
Vacuum heat transfer machine (3d) we-cpi...guger heat transfer plastic decoration machine vacuum 3d we-cpi we...samples of product made by the machine in the above photos!- please see the photos for machine...
$ 3200
-
Though the car has never been dynoed, the machine shop believes it to be in the neighborhood of 400hp...in addition to the color, it was decided that it would have all of the rally sport options...
$ 59900
-
The reasons are: the con's, the engine block has a crack in cylinder wall #6 that was not noticed at the machine shop, when it was blocked & cleaned, and was not noticed until the entire engine was installed...
$ 3000
-
It was built by the machine shop located in lindon utah...the rear end is a 12 bolt rear end and i had it rebuilt and added an eton locker...vehicle is located in provo ut...it is a 388 stroker...
$ 11500
-
This car is extremely well-documented with a massive binder full of receipts, invoices, dyno charts, a cam card, even the machine shop’s hand-written calculations to get the compression ratio right...
$ 44900