Stud girdles

List stud girdles

  • Howards afr stud girdles...  moser stud girdle cover...  battery relocated to bed...  dual fan kit variable speed setup cfm...  coated cam bearings...  b&m stealth magnum 4 speed shifter...

    $ 7000

  • Roller short travel lifters- beehive springs- probe rocker stud girdles...7 rockers- lobe separation 109*- intake lobe centerline 106*...ford mustang fastback...clone) cnc ported by mark jeffrey at trans...

    $ 45000

  • 5 pistons, afr air flow research fully cnc machined heads, comp roller cam, roller rockers, stud girdles, gear drive timing set, demon carb, edelbrock intake, msd pro billet distributor, msd digital 7...

    $ 29500

  • Power comes from a 454 cu-in v8 with a trubo 400 automatic transmission and 12 bolt posi rear! the 454 was built with solid roller rocker lifters and stud girdles, msd ignition, edlebrok performer 4 bbl...

    $ 33000

  • Motor: lt-1 4-boltmain,30 over,balanced 7:1 blower pistons pink steel rods/steel crank b&m blower cam kit roller rockers/stud girdles don hamton 671 blower/ 12 lbs of boost/dual 750 carbs,3" drive belt/mph...

    $ 46500

  • This is my chevy 210 pro street, it has a 355 small block with an eagle forged crank, eagle rods, speed pro pistons, dart pro 1 aluminum heads ported and polished, stainless steel valve springs, 7/16...

    $ 15100

  • Trick flow stud girdles, rocker arms and push arms...clevitte h bearings...ford racing boss 351 block...promotion powertrain built tko 500 and clutch...lash caps, custom je pistons, eagle h-beam rods,...

    $ 10000

  • 5 to 1 compression forged pistons, polished aluminum heads, jomar stud girdles, manley valves, comp cams chrome moly retainers & locks, comp cams springs, roller rockers, polished intake, 871 supercharger...

    $ 2638

  • Dodge dart gts custom “cannonball run” style  vin ls23p8e miles ( at restoration) complete ground-up  body-off restoration original ca black plates (that were issued with this car new)  hi performance...

    $ 200

  • Harland sharpe stud girdles and rockers...i’m selling due to health reasons...all suspension parts replaced and upgraded...very little rust (see pics)...car is very solid! this car has not been cut, molested...

    $ 16000

  • Underthe valve covers are crane full roller rockers with stud girdles...cruises down the road straight with 1 finger at 70 mph...it also has the correct cross members for throughthe frame exhaust...

    $ 2900

  • 9 to 1)…aluminum edelbrock mondello stage 3 heads cnc ported…harland sharp roller rockers w/stud girdles…...arias pistons (11...fans, 16 gal harwood fuel cell, fluid damper balancer  fiberglass fenders...

    $ 1000

Did not find what you're looking for? Try again

Related Searches stud girdles