Spindles machined

List spindles machined

  • Super bell axle with 54 chevy spindles machined for later model rotors calipers...note edged and weight...stock rear drum brakes modified slapper traction bars to fit gm platform and chrysler rear axle...

    $ 45900

  • Mustang ii spindles modified for larger inner bearings...spindles from lincoln mark 8 w/ new bearings...custom machined aluminum mounts used to eliminate rubber grommets and associated flex and movement...

    $ 48995

  • Rear drums have been machined and drilled to the very lightest possible...the axle mounting surface has been machined down to the lug bolt surface, the axle has been machined concave and drilled to remove...

    $ 3999

  • The custom machined throw-out bearing, machined by john mummert, is new...9" ford rear, new housing,31 splined axles, bearings, studs, seals, vent, hardware rear axle fab, tig weld ladder bar mounts, spring...

    $ 9500

  • New!!!  socal  stock width hiboy base frame with coil over rear suspension all parts are socal complete chrome 4" drop 47" front end w/ mono leaf spring, hairpins, bushed spindles chrome shocks 55" rear...

    $ 6800

  • Frame off restoration with no expense spared - every inch of this truck has been fabricated, machined and built to the max...interior this c10 has been tastefully restored to create a modern, fresh, and...

    $ 1000

  • 5"dropped spindles front, new axles in rear, new dash all gauges work, and all undercoated, and insulated, all glass is stock size...this car had the top cut off and the windshield raked back 5", so i...

    $ 13500

  • The 496 stroker engine was built on a gen 5 block that was professionally machined and built with afr aluminum 325 heads eagle crank stroker, scat h beam rods, probe pistons, plasma moly rings, king bearings...

    $ 65000

  • I got a set of custom drop spindles and lower control arms, and new sway bar...  i even had the truck arms machined so the e- brake cable would run through it and not hang below the chassis...

    $ 10100

  • The 3" coils springs are also adjustable using machined aluminum spanners...    brakes / driveline / performance  currie rockjock dana 60 front 1 ton complete axle assembly  - $ currie rockjock dana 60...

    $ 5100

Did not find what you're looking for? Try again

Related Searches spindles machined