Sheet metal
List sheet metal
-
Front to rear, nearly every piece of sheet metal is carefully recrafted for a striking, muscular look, starting with new projector headlamps, led lighting, and the signature split crosshair grille...
$ 30730
-
• original build sheet...it’s believed to retain all the original sheet metal...there wasn’t any rust so no sheet metal work was needed...to larry’s knowledge all the sheet metal is original to the car...
$ 399005085570152
-
New old stock sheet metal was collected over the years prior to rebuild...gm nos sheet metal was located and purchased one piece at a time...all of the sheet metal were thoroughly stripped, prepared, primed...
$ 125000
-
I think a sheet metal tech could remove it simply as it is easily accessed... both front and rear valances (sheet metal below bumpers)... if you pick it up with an open trailer you'll need extra space...
$ 900
-
In addition i have the stainless steel “pinch weld” trim that goes around the convertible top where it meets the sheet metal... the body does need some work, but all the original sheet metal is intact...
$ 100
-
Having traversed only documented miles, it boasts its original 130 hp, 236 ci inline 6-cylinder engine and 4-speed transmission with dual-range 4-wheel drive and sheet metal...side "man door"...
$ 125000
-
Retains most of the original sheet metal...the car retains most of its original sheet metal... i’ve found that high percentage of the few listed for sale aren’t properly documented, haven’t been restored...
$ 250000
-
Hi i am selling a belair original ca car super solid with over $60k invested in custom frame, sheet metal and suspension parts...the rear trim, front and rear bumpers where professionally lead into the...
$ 25000
-
sheet metal items email for more picture...have all new dynacorn sheet metal for complete car...over $ in new sheet metal… 1-rh and lh detroit speed mini tubs 2-new quarter skins 2-new fenders ...
$ 8500
-
In addition to the sheet metal mentioned above, the car comes with one new fender (drivers side) and an oem rear hatch...the other side remains to be finished, but all of the sheet metal required to complete...
$ 2500