Bell housing
List bell housing
-
The original 4-speed bell housing has been modified by john mummert to accept a ford mustang t5 manual transmission...9" ford rear, new housing,31 splined axles, bearings, studs, seals, vent, hardware...
$ 9500
-
From the front of the zf 5 ds 25 (dash 2) transaxle it is approximately 35 inches without the bell housing and approximately 30 inches from the front of the bell housing to the bulkhead/firewall crossbar...
$ 22000
-
Remove axles, disconnect bell housing, remove trans and torque tube, remove remainder of f1 harness from car, remove fiberglass insulation tunnel...remove hydraulic hose to bell housing, swap out t/o bearing...
$ 272000
-
Clutch, and a sfi blow-proof bell housing...a x-factor custom transmission crossmember, and an sfi approved blow-proof bell housing, a heidt's front end, chris alston's rack-n-pinion steering, cpp tubular...
$ 49500
-
It's got a jaguar rear end, fully boxed frame, explosion proof bell housing and a huge aftermarket oil pan; this car is set up for speed and handling, nothing else...030 over) - ford 351ci windsor heads...
$ 44900
-
But what really makes this cobra special is what's under the hood; a 427ci side-oiler v8, one of the best engines ford ever produced, even better is what this monster motor is paired to: a toploader 4-speed...
$ 62900
-
A mini starter, explosion proof bell housing, oversized oil pan and much more can be seen...com at a glance: - 427ci v8 engine (#:6f12) - tko 5-speed transmission - front independent suspension - rear...
$ 59900
-
8l s10, with a ford bell housing... one minor repair it needs is a grade 7 bolt replaced in the slave cylinder into the bell housing... the truck is one of a kind, custom because chevy didn't make...
$ 1500
-
Very correct vette with the original, 4 speed muncie, original intake and exhaust manifold, original bell housing and both intake and exhaust manifolds are original...) exhaust manifold: (' (orig) 4 speed...
$ 200
-
It's got a jaguar rear end, fully boxed frame, explosion proof bell housing and a huge aftermarket oil pan; this car is set up for speed and handling, nothing else...030 over) - ford 351ci windsor heads...
$ 44900
-
The bell housing is larger in order to accommodate the stator, which means you probably could not just swap out the guts...the way the batteries recharge is based off a stator that is around the outer...
$ 4500